TLR calipers on TLS. Stainless steel line ?

[Stabber]

I'm going to find some TLR calipers for my TLS. My question is I'm going to go ahead and get the ss lines and pads now but I was wondering if its ok to get the TLS lines or do I need the TLR lines. Are they different lengths or have different ends. Thanks for any help

[muguvian]

...

Get the TLS lines (slightly longer). Fittings are the same.

[TLSBill]

Get Kevlar.. They're spiffarific!

[Stabber]

I think motoextreme has the set of lines and pads together. I think they are gafler pads , they are probably as good as the EBC HH pads

[TLSBill]

HH is a rating.. It's not specific to EBC.. so any brand rated HH should be fine.

[Dover338]

anybody know where good deals on SS lines are. I just got the TLR callipers and master cylinder, but I need some lines. I've heard Russell lines are good and cheap? any suggestions

[Stabber]

Here is the ones I've been looking at clicky clicky

[BurnCycle]

When I did this swap I went with Goodridge Kevlar lines. I also went with the lines for the TLR since I changed the master cylinder and calipers. The TLR lines are more than long enough on the TLS.

[TLSBill]

Originally posted by Dover338
anybody know where good deals on SS lines are. I just got the TLR callipers and master cylinder, but I need some lines. I've heard Russell lines are good and cheap? any suggestions

DO NOT BUY RUSSELL.. They are crap and the fittings go bad on you at 140mph.... Causing you to turn a perfectly good GSXR into a twisted pile of crap.

Get something reputable or go to Earl's and make your own. You can even pressure test them there I think.